Tuesday, October 25, 2011

I have gas in my oil and need help are my rings and bearings still good?

My question isnt how it got there. It went through the rings, the gas was poured in the carb to prime the fuel pump. my fuel pump is good, my carb is good. Also It flooded it because i have a highrise intake and big carb also have a cam etc, and used the old spark plugs to attempt to test the engine. To much gas, not enough spark, flooded it. The thing is, is that i never managed to start it although i turned it over a good bit, i was wanting to know how likely it is that my bearings and or rings are messed up? thats the question.... Im praying that new spark plugs and an oil/filter change fixes the problem, im also planning to buy a high performance distributor/coil/cap. Please .let me know what you think. Thanks alot. K.C.I have gas in my oil and need help are my rings and bearings still good?diablo you need to do a compression test to see if the rings are all good. a tester should run around 25 dollars or so more for better quality type. then you have the motor cranked 5 vevelutions each cylinder , writing the numbers you get. the variation should be less than 15 lbs or so any that read drasticly different should be rechecked and then noted. much lower would be blown rings. ps you dont prime a fuel pump pouring fuel into an engine thats just priming the cylinders.

www.mycarandineedhelp.com its free and its meI have gas in my oil and need help are my rings and bearings still good?Just cleaned everything Drain and run a air hose in the oil plug%26gt; with oil fill off it will dry out the gas%26gt; Fill and run%26gt;I have gas in my oil and need help are my rings and bearings still good?Don't go completely off my source because im just a garage mechanic with no schooling, but i wouldn't think the rings and bearings would go bad, the only thing i know of that causes that is substances such as metal shavings from old parts, ect. getting in between the bearings and scraping them up.I have gas in my oil and need help are my rings and bearings still good?I would replace the rings to be safe, i doubt it hurt them but id rather be safe than sorry.I have gas in my oil and need help are my rings and bearings still good?probably washed down the rings not a big problem you will have to crank it until compression comes up without feeding it anymore fuel crank it a few times to get oil back into the rings make sure you are up on number one on the compression stroke if you have spark it should fire and run bad for a while then get better set timing

No comments:

Post a Comment